How To Install Teak Wood Flooring

>

Hardwood floors are the finest option for adding additional beauty and class to the room. These floors are typically nailed to the wooden sub floor rather than gluing it. When installing the teak floor on the concrete, plywood should really be laid as the subfloor. Here are few tips to install on the concrete surface.

Initial the concrete surface is required to be cleaned correctly by removing any dirt or dust. The cracks or gaps in the cement need to be covered with the epoxy mortar to make it smooth. The patch can be smoothened working with a trowel. Then the applied mortar must be left to dry for few hours. After this, electric sander can be utilised to sand the rough surface of the base floor and make it smooth.

Next, mastic can be applied over the cement slab and leave it to dry for at least three hours. A polyethylene sheet requirements to be laid on the entire floor. Soon after all these settings, plywood sub-floors are laid on the base. About ½ inch gap can be left between every piece of wood due to the fact the wood has the tendency to expand due to the climatic modifications. The plywood can be attached to the cement floor by indicates of concrete fasteners or masonry nails. At least four nails have to have to be utilised to nail down the plywood sheets to a floor for the firmness. Now, the hardwood floor can be nailed appropriately over the plywood sheets. From the grooved edge, the nailing method of the woods can be started, and calculated gaps can be left between every nail.

Soon after finishing the total floor, the last row can be cut with respect to the floor size. In the exact same way, the should really also be done by leaving at least ½ inch gap as these also expand throughout the change in weather.